Turn on your TV and scan for channels Your TV is ready for viewing Sceptre wants to help you save energy! This HDTV meets the ENERGY STAR® guidelines. The default setting for this HDTV is set to POWER SAVING mode. You can change this setting by pressing the PICTURE button on the remote control twice.
To attach the stand place the display unit flat on a table. Afterwards attach the stand onto the display and screw in the 4 screws to secure the stand. Rear View Mounting Pattern Mounting Specification: 200mm x 200mm using screw size M5. Length of screw should not exceed 9mm. Please Note: The 9mm length of screw refers to how deep the screw can go inside the mounting holes.
Page 3
3. Installing Batteries to the Remote Please insert two AAA batteries into the remote control. Make sure that you match the (+) and (-) symbols on the batteries with the (+) and (-) symbols inside the battery compartment. Afterwards, re-attach the battery cover. Please note: •...
Ready to Watch Some TV? Starting up the HDTV Make sure your power cable is connected and the standby red light in the front of the HDTV is lit up. Check all your connection cables off the side or the back of your TV and also your AV devices.
Page 6
Use the ▲ or ▼ buttons to select AUTO CHANNEL SEARCH and press to scan ENTER for channels. Once the scanning finishes, you can begin to watch HDTV If You’ve Connected set-top boxes to the HDTV… Press the S button on top of the HDTV or the SOURCE button on the remote control and you will see the picture above.