Installation - Salus PL07 Instruction Manual

Salus PL07 Manual Ver007.qxd:Layout 1 10/9/10 10:03

INSTALLATION

Please read the important safety information at the start of this manual before
you begin to install the device.
NOTE: All electrical installation work should be carried out by a suitably
qualified Electrician or other competent person.
If you are not sure how to install this logic module consult either with a qualified
electrician, heating engineer or your boiler / heating system supplier for advice
on how to continue.
The PL07 logic module is not a standalone unit, and is intended to be mounted
on a KL06 wiring centre. The wiring centre should be installed first, followed by
the PL07 logic module.
To install the logic module, undo the securing screw on the wiring centre, insert
the logic module and then refit and tighten the securing screw.
The PL07 logic module should be mounted in a location where it will not come
into contact with water, moisture or condensation. The location should also be
accessible for the connection of mains and control wiring.
PL07 INSTRUCTION MANUAL 5