Drivers And Programming Software For Advanced Users; Installation For Users Of Windows 2000 - Saitek Cyborg evo Wireless User Manual

5. At the Driver Setup screen, plug in your wireless receiver dongle and click on Next.
6. At the Driver Setup screen, click Next to test your controller.
7. When the Saitek Controller screen appears, try out all your controller's buttons and controls to
show that it is working properly. When you have finished, click OK.
8. At the Software Setup screen, select Do not install the SST Programming Software and click
Next. The Programming Software can be installed at a later date by following instruction (b)
below
9. At the Registration screen, select Check this box to register now and follow the on-screen
instructions, or you can choose to select this option later.
10. Click on Finish to complete the installation.
b) Drivers and programming software for advanced users
1. Follow points 1 – 7 of the install procedure in A), then at the Software Setup screen, select Install
the SST Programming Software and click Next.
2. In the following Software Setup screen, click Next and follow the on-screen instructions. At this
point you will be asked to install such features as the Saitek Magic Mouse, HID-compliant mouse,
Saitek Magic Keyboard and HID Keyboard Device (these are what XP calls the various elements
of your Saitek controller). Continue to click on Next and Finish to accept the installation until the
Registration screen appears.
3. At the Registration screen, select Check this box to register now and follow the on-screen
instructions, or do not select this option and register later.
4. Upon completion of the installation, you have the option to Run Profile Editor, which will give you
a view of the 3D programming environment. If you do not wish to see the Profile Editor at this
point, just uncheck the box and click on Finish to complete the installation.
Installation for Users of Windows® 2000
a) Drivers only for typical users
1. With your computer switched on, close down any programs that are currently running and insert
the Saitek Smart Technology CD into your CD-ROM drive.
2. When the Introduction Screen appears, click Install Software to continue.
3. When the Welcome screen appears, click Next to continue. (If the CD does not run
automatically, select Start from the Windows® Taskbar, then Run and type D:\Setup.exe and
click OK - where D:\ is letter of your CD-ROM drive).
4. After reading the Disclaimer, select the I accept the terms of the Disclaimer option and click
Next to continue.
5. At the Device Driver Installation screen, click on Next and follow the on-screen instructions.
6. When prompted, plug your controller's USB connector into your computer, then click on
Configure.
7. When the Controller Properties screen appears, click Next to view the Test screen.
8. Now try out all your controller's buttons and controls to show that it is working properly. When you
have finished, click OK.
9. At the Programming Software screen, select Typical User and click Next.
10. At the Registration screen, select Register and follow the on-screen instructions or select
Register Later and click Next.
11. Click on Finish to complete the installation.
b) Drivers and programming software for advanced users
1. Follow points 1 – 7 of the install procedure in A), then at the Programming Software screen,
select Advanced User and click Next.