Page 1
Inside this manual you’ll find details about your HV Series model. Everyone at Kustom wishes you many years of enjoyment with your new amplifier!
Page 2
FCC Statements 1. Caution: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 2. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Page 5
1.) Guitar Input Jack - this is a 1/4” 2-conductor input jack for plugging in your instrument. It is in- tended for guitars but will accept other instruments as well. 2.) Lead Gain - adjust this clockwise to increase the amount of distortion. At lower ranges of the con- trol, you get a less distorted sound.
Page 6
Reverb Level - This control adds Reverb to the preamp/effects mix. It simulates the spring reverb pan found in vintage tube amps. The Reverb Level is independent from the three Effects controls. Effects Level - This control adds the effects section and mixes it into the main signal. Eight different effects are available.
Page 7
The ring selects the effects active/off. This foot-switch is not included with the amplifier. Kustom model KAC-FS201 is recommended to enjoy all the features. *Power Switch on bottom rear chassis* - this switch turns on and off the AC power to the amp.
Page 8
1.) AC Power Cord Receptacle - AC power cord can be removed for easy storage and replacement if damaged. Insert the AC cord (provided) firmly into the AC receptacle. NOTE: Replace the AC power cord if protective jacket is damaged or ground pin is damaged or removed. 2.) Fuse - The fuse is located in a fuse tray just below the receptacle.