Summary of Contents for Kustom High Voltage HV 65T
Page 1
Inside this manual you’ll find details about your HV Series model. Everyone at Kustom wishes you many years of enjoyment with your new amplifier!
FCC Statements 1. Caution: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 2. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Page 5
1.) Guitar Input Jack - this is a 1/4” 2-conductor input jack for plugging in your instrument. It is intended for guitars but will accept other instruments as well. 2.) Lead Channel On LED - when this LED light is on, it indicates that the Lead Channel is active. 3.) Lead Gain - adjust this clockwise to increase the amount of distortion.
Page 6
Effects Module Memory - Aside from all the versatility of the built-in effects, the effects module in your Kustom amplifier has the ability to store your favorite sounds. All the most recent changes to the Toggle Tap button are saved in each of the 16 effect locations. For example, If you tap in your favorite delay time, then go to chorus, and then go back to delay, your own tapped delay time will still be saved.
Page 7
3 switches through a simple stereo cable. The tip selects the Rhythm or Lead channel. The ring is multifunction for the overdrive on/off switch and the effects active/off switch. This foot-switch is not included with the amplifier. Kustom model KACFS-301 must be used to enjoy all the features. In an emergency, a mono single-conductor shielded instrument cable and single button foot-switch can be used to allow switching of the channels only.
Page 8
1.) AC Power Cord Receptacle - AC power cord can be removed for easy storage and replace- ment if damaged. Insert the AC cord (provided) firmly into the AC receptacle. NOTE: Replace the AC power cord if protective jacket is damaged or ground pin is damaged or removed. 2.) Fuse - The fuse is located in a fuse tray just below the receptacle.
Need help?
Do you have a question about the High Voltage HV 65T and is the answer not in the manual?
Questions and answers