Advertisement
Quick Links
Advertisement
Related Manuals for Kogan KAHPH24WLSA
Summary of Contents for Kogan KAHPH24WLSA
- Page 1 KAHPH24WLSA USER MANUAL...
- Page 2 Introduction Thank you for choosing our 2.4G wireless headphones product. These 2.4G Wireless Headphones have been designed for receiving wireless high-quality stereo sound from audio playback devices. The range of the wireless signal is up to 25 m (75 ft) outdoors and 50 m (150 ft) indoors under optimum conditions, depending on the environment.
- Page 4 5. Connect the other end of the cable to the headphones output socket of your hi-fi equipment. (If your hi-fi equipment has a 6.3 mm jack socket, connect the adapter plug to the audio cable. You may also connect the adapter cable (see page 1 – Package Contents) to the cable to use the Cinch audio outputs of your hi-fi equipment.) 6.
- Page 5 10．According to your different requirement to adjust the voice volume ( press the VOL+ or VOL-), as shown in the following pictures:...
- Page 6 11.When you used up the power stored the Li-battery, and then you want to continue to listen to the music, you can insert two AAA batteries into the battery compartment which is located on the left of the receiver. Make sure you match the correct polarity. Note the + and –...
- Page 7 16. Note: When the stored power is not enough for use, the transmitter light will turn orange, and when the Li-battery be finished it’s charge the transmitter light will turn green. (For best battery life, charge Li-battery with 8-12 hours when you use it at first time), please see the following pictures:...
- Page 8 Receiving Radio Stations 1. Put the left button of the receiver to ON, at the same time put the right functional button of the receiver to FM. The receiver will now begin to operate FM function in 87.5MHZ-108MHZ . The 2.4G function will not occur. Please see the flowing pictures: 2.
- Page 9 6. The FM signal reception depends on environmental conditions. If the desired station cannot be received without noise or interference, try changing your location. The last tuned-in station will not be saved when changing the operating mode or after powering the headphones off. To use the built-in FM tuner it is not necessary to power the transmitter cradle on.
-
Page 10: Appendix Troubleshooting
Troubleshooting You can solve most common problems yourself by using the following hints. If the problem persists after checking the suggested solutions, please contact the Kogan service center. Do not attempt to repair the product yourself. The headphones do not power on, there are no indicator lights. -
Page 11: Technical Specifications
Technical Specifications Model Wireless stereo headphones with FM radio Frequency response 22 - 20,000 Hz Signal to noise ratio 50 dB R/L channel separation 30 dB Carrier frequency 2.40 – 2.48 GHz (WLAN hopping) Modulation digital Maximum transmission 9.9 dBm power Radio tuning band FM Radio 87.5 MHz to 108 MHz...