Reversing Switch Action; Speed Change; Adjusting The Fastening Torque - Makita 6095D Instruction Manual

1. Reversing switch
1
2
3 4
1. Arrow
2. Speed change knob
3. L: Low speed
4. H: High speed
1
2
1. Adjusting ring
2. Pointer

Reversing switch action

002085
This tool has a reversing switch to change the direction of
rotation. Slide the reversing switch to the right (appear "F"
1
marking) for clockwise rotation or to the left (appear "R"
marking) for counterclockwise rotation.
CAUTION:
• Always check the direction of rotation before operation.
• Use the reversing switch only after the tool comes to a
complete stop. Changing the direction of rotation before
the tool stops may damage the tool.

Speed change

002093
To change the speed, turn the speed change knob so that
the arrow of the desired speed on the knob is aligned with
the reference arrow on the tool body. If the speed change
knob does not turn easily, switch on the tool and turn the
knob again while the tool is running under no load. Be sure
that the speed change knob is set to the correct position
before operation. Use the right speed for your job.

Adjusting the fastening torque

002100
The fastening torque can be adjusted in 6 steps by turning
the adjusting ring so that the pointer on the adjusting ring
points to a number on the tool body. The fastening torque is
minimum when the pointer points to the number 1 and maxi-
mum when it points to the
The clutch will slip at various torque levels when set at the
number 1 to 5. The clutch is designed not to slip at the
marking.
Before actual operation, drive a trial screw into your material
or a piece of duplicate material to determine which torque
level is required for a particular application.
NOTE:
• The adjusting ring does not lock when the pointer is
positioned only halfway between the numbers.
marking.
11