Before First Use - Kalorik USK MGR 25959 Operating Instructions Manual

Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The page must be reproduced and folded in order to obtain a
booklet A5 (+/- 148.5 mm width x 210 mm height). The page must be
folded in order to keep the good numbering when you turn the page
of the I/B . Don't change the page numbering. Keep the language
integrity.
IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the
requested breaks. Failure to follow this instruction carefully may result
in damage to the motor. Please refer to the rating label for the
maximum continuous usage time (KB xx min where xx is the maximum
usage time). The breaks should last at least 10 minutes.

BEFORE FIRST USE

It is necessary to clean all accessories (see paragraph "cleaning and
care") and to dry them.
ASSEMBLY OF THE ACCESSORIES AND OPERATION
Make sure the power cord is unplugged and the ON/OFF switch is in
OFF position before assembling the accessories. This instruction
should be observed each time you assemble or replace accessories.
Unscrew the locking screw by turning it anti-clockwise and insert the
filling neck in the motor block.
Once the filling neck is positioned correctly, tighten the locking screw
by turning it clockwise (Fig. 1) and make sure it is tightly connected
to the motor block.
Put the worm on the motor shaft (Fig. 2) that you can see at the end
of the filling neck (to check if it is positioned correctly, it should not
be possible to turn it with the hand).
A) Discs
These accessories allow mincing meat. According to the disc
•
you choose, you can obtain more or less finely minced meat.
Place the blade upon the worm with its rounded side facing the
•
worm. (Fig. 3)
Assemble one of the 3 discs upon the blade, making sure that its
•
two arresting pins lock precisely into the corresponding recesses.
(Fig. 4).
6
Assembly page 6/24
USK MGR 25959 - 080630