Table Of Contents; Table Of Contents / Introduction - Ryobi JM80 Owner's Operating Manual

1. Table of Contents / Introduction ............................................................... 2
2. Rules For Safe Operation ..................................................................... 4-6
3. Features ................................................................................................ 7-8
4. Adjustments .........................................................................................9-10
5. Operation ........................................................................................... 11-16
6. Maintenance ......................................................................................17-19
7. Accessories ............................................................................................. 19
8. Troubleshooting...................................................................................... 20
9. Service Information ................................................................................ 22
Spline joinery is one of the strongest methods of joinery
used in woodworking. When glue is properly applied to a
spline and to the joint area of the wood pieces being
connected, a large surface area receives the adhesion
properties of the glue. This forms a very strong joint.
Traditional spline joinery requires cutting slots with a router
or table saw. Small, thin strips of wood must then be cut to
fit inside the slots and act as splines.
Newer methods of spline joinery use a plate or biscuit
joiner to cut precise mating oval slots in adjoining boards.
Your new plate joiner is a fast, simple, and accurate plunge
cutting tool that can be used for this purpose. It can be
used to cut slots in hardwood, softwood, plywood, particle
board, and other pressed woods.

Table of Contents

INTRODUCTION
Football shaped wafers, called biscuits, are then placed
inside the slots with glue and used to help line up adjoining
surfaces. When a water based glue is used, the biscuits
swell in the joint, making an extremely strong and firm
bond. White glue, yellow glue, carpenters glue, hide glue,
and aliphatic resin glue are examples of water based glues.
This bonding technique has traditionally been limited to
making edge-to-edge joints. However, with the use of your
new plate joiner, biscuits can now be easily used to con-
nect butt, miter, and T-joints. Biscuit joining can be as
strong as mortise and tenon, tongue and groove, standard
spline, and doweled joints. In most cases the material
around the biscuit will break before the biscuit itself will
break. A greater surface area is exposed to glue in a biscuit
joint, making the seams stronger.
Page 2