Features; Symbols - Ryobi P201 Operator's Manual

SERvIcE
Servicing requires extreme care and knowledge and should
be performed only by a qualified service technician. For
service we suggest you return the product to the nearest
AUThORIZED SERvIcE cENTER for repair. When servicing,
use only identical replacement parts.
WARNINg:
The operation of any power tool can result in foreign objects being thrown into your eyes, which can
result in severe eye damage. Before beginning power tool operation, always wear safety goggles or
safety glasses with side shields and, when needed, a full face shield. We recommend Wide Vision
Safety Mask for use over eyeglasses or standard safety glasses with side shields. Always use eye
protection which is marked to comply with ANSI Z87.1.
PRODUcT SPEcIFIcATIONS
Motor ..................................................................18 Volt DC
Switch ............................. VSR (Variable Speed Reversible)
KNOW YOUR DRILL-DRIvER
See Figure 1, page 12.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
BIT STORAgE
Bits provided with the drill can be placed in the storage
areas, located on the base of the drill.
DIREcTION OF ROTATION SELEcTOR
(FORWARD/REvERSE/cENTER LOcK)
Your drill has a direction of rotation (forward/reverse/
center lock) selector located above the switch trigger for
changing the direction of bit rotation. Setting the switch
trigger in the OFF (center lock) position helps reduce the
possibility of accidental starting when not in use.

SYMBOLS

SAvE ThESE INSTRUcTIONS

FEATURES

6 — English
WARNINg:
To avoid serious personal injury, do not attempt
to use this product until you read thoroughly and
understand completely the operator's manual. If you
do not understand the warnings and instructions in the
operator's manual, do not use this product. Call Ryobi
customer service for assistance.
No Load Speed .......................0-440/0-1,600 r/min. (RPM)
Torque .................................................................. 330 in.lb.
KEYLESS chUcK
The keyless chuck allows you to hand-tighten or release the
drill bit in the chuck jaws.
MAgNETIc BIT hOLDER
The magnetic bit holder extends the reach of the bit and
holds the bit and screws until you are ready to drive them.
Storage is located on the front of the drill's base.
MAg TRAY
™
The Mag Tray conveniently stores screws or other small
™
parts.
QUIcK MODE SELEcTOR
The Quick Mode Selector allows you to quickly switch from
drive mode to drill mode.
TORQUE ADJUSTMENT RINg
Your drill has a 24-position clutch. The torque adjustment
ring can be turned to select the right amount of torque for
your application.