Turn On The Br-532; Adjusting The Display Contrast; Play Screen - Boss Digital Studio BR-532 Owner's Manual

Listening to the Demo Song

(2) Turn on the BR-532

Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
1. Before you turn the power on, make sure of the
following points.
Are all external devices connected properly?
Is the volume on the BR-532 and all other devices
completely lowered?
Is the memory card inserted?
* The BR-532 is shipped with a memory card already inserted in
the slot.
2. Turn off the AUDIO SUB MIX switch on the rear panel.
fig.Q01-05a
3. Lower the MASTER fader on the BR-532.
fig.Q01-05b
4. Turn on the device connected to an input jack (i.e.,
GUITAR/BASS, MIC, or LINE IN).
5. Turn on the POWER switch located on the rear panel.
fig.Q01-06a
* Always make sure to have the volume level turned down before
switching on power. Even with the volume all the way down,
you may still hear some sound when the power is switched on,
but this is normal, and does not indicate a malfunction.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
6. Turn on the device connected to the output jack (i.e.,
LINE OUT or DIGITAL OUT).
24
If you are using the AC adaptor, make sure that the AC
adaptor does not become unplugged during operation. If
the AC adaptor becomes unplugged accidentally, the
recorded data may become damaged.

Play Screen

The Play screen is the most fundamental screen of the
BR-532, and is the first screen that appears when the BR-
532 is turned on (see below).
fig.Q01-06b
* You can set the BR-532 so that the remaining recording
time is displayed during recording. Refer to "Displaying
the remaining available recording time" (p. 73).

Adjusting the Display Contrast

Depending on where the BR-532 is situated, the display
contents may be difficult to read. If this is the case, perform
the procedure given below to adjust the contrast (1 to 15).
1. Press [UTILITY].
fig.Q01-08
2. Press PARAMETER [
"SYS," and press [ENTER].
3. Press PARAMETER [
and adjust the contrast with the TIME/VALUE dial.
fig.Q01-50
4. After completing the adjustment, press [EXIT]
repeatedly to return to the Play screen.
* During automatic updating, "Keep Power On!" appears in the
upper line of the display, while the lower line shows what is
being processed.
You can turn the TIME/VALUE dial while pressing [UTILITY]
to adjust the contrast. Use each procedure as appropriate.
] [ ] to move the cursor to
] [ ] to select "LCD Contrast,"