Jeep Wrangler Owner's Manual page 380

ESP function normally. This mode is intended to be used
if the vehicle is in deep snow, sand, or gravel conditions
and more wheel spin than ESP would normally allow is
required to gain traction. To turn ESP on again, momen-
tarily press the ESP OFF switch. This will restore the
normal "ESP On" mode of operation.
ESP OFF Switch
NOTE: To improve the vehicle's traction when driving
with snow chains, or starting off in deep snow, sand, or
gravel, it may be desirable to switch to the "Partial Off"
mode by pressing the ESP OFF switch. Once the situation
requiring ESP to be switched to the "Partial Off" mode is
overcome, turn ESP back on by momentarily pressing the
ESP OFF switch. This may be done while the vehicle is in
motion.
ESP Off (4H Range Only)
This mode is intended for off-highway or off-road use
when ESP stability features could inhibit vehicle maneu-
verability due to trail conditions. This mode is entered by
pressing and holding the ESP OFF switch for five seconds
when the vehicle is stopped and the engine is running. In
this mode, all ESP and TCS stability features are turned
off except for the "limited slip" feature described in the
TCS section. After five seconds, a chime will sound, the
"ESP/TCS Indicator Light" will illuminate, and the "ESP
OFF message will appear in the odometer. Refer to
STARTING AND OPERATING 379
5