Quick Start - iHome iW1 air series User Manual

Quick Start

Power
1
Connect to power source
outlet
12V
iPod Local Audio Mode
1
Dock iPod/iPhone using iPod USB sync cable
(iPod and aux-in play in parallel)
battery power
off | on
AirPlay Wireless Audio Mode
1
Verify that your iW1 speaker is successfully
connected to your Wi-Fi network.
(visit page 8 for connecting your iW1 speaker to your
Wi-Fi network)
status network setup
battery power aux-in iPod dock reset status network setup
off | on
Connected Not Connected
AirPlay Wireless Audio Mode
4
Select the iHome iW1 as your AirPlay
audio speaker
Look for the AirPlay logo
to select your speaker
English
2
Place iW1 on charging base
2
Press
aux-in iPod dock reset status network setup
(visit pages 8-9 for Wi-Fi network configuration)
2
Press
status network setup
battery power aux-in iPod dock reset status network setup
off | on
5
Press
use your iTunes, iPad, iPhone, or iPod
touch controls directly.
Adjust volume on the iW1 or wirelessly
control volume on your AirPlay source
device.
3
Turn master power switch ON
battery power aux-in
off | on
battery
for iPod mode
for AirPlay wireless mode
buttons on the iW1 or
4
Press
power
iPod dock reset status network setup
off | on
allow 30s for the
iW1 to startup
3
Press buttons on the iW1 or
iW1 remote, in iPod mode, to control
your iPod music.
Adjust volume by swiping:
Note: Use iPod mode for both iPod
docking and Aux-in audio playback.
3
Launch iTunes or use your iPad, iPhone,
iPad touch. Verify iW1 and AirPlay source
device is on same Wi-Fi network.
AirPlay only works with iPod touch, iPhone, iPad,
or iTunes (Mac or PC)
!
Note: for AirPlay streaming:
iPad, iPhone, and iPod touch support
point-to-point audio streaming to one
AirPlay enabled speaker.
iTunes supports point-to-multipoint audio
streaming to up to three AirPlay enabled
speakers (performance depends on your
Wi-Fi network and environment).
power button
5