Service And Adjustments; To Remove Drive Belt - Husqvarna HD775HW Operator's Manual

961430086

Hide thumbs Also See for HD775HW:

Operator's manual (44 pages)

Table Of Contents

Table of Contents

CAUTION: to avoid serious injury, BEFORE

PERFORMING ANY SERVICE OR ADJUSTMENTS:

1. Release control bar and stop engine.

2. Make sure the blade and all moving parts have

completely stopped.

3. Disconnect spark plug wire from spark plug

and place where it cannot come in contact with

plug.

LAWN MOWER

TO ADJUST CUTTING HEIGHT

See "TO ADJUST CUTTING HEIGHT" in the Operation

section of this manual.

REAR DEFLECTOR

The rear deflector, attached between the rear wheels of

your mower, is provided to minimize the possibility that

objects will be thrown out of the rear of the mower into

the operator's mowing position. If the deflector becomes

damaged, it should be replaced.

TO REMOVE DRIVE BELT

1. Remove screws securing rear baffle (Figure 24).

2. Turn lawn mower on its side with air filter and car bu re-

tor down.

3. Remove rear baffle from mower.

4. Remove blade bolt, lockwasher, hardened washer and

blade.

5. Remove screw securing debris shield.

6. Remove gearcase belt keeper.

7. Remove drive belt.

TO REPLACE DRIVE BELT

1. Place new drive belt on gearcase pulley (Figure 24).

NOTE: Always use factory approved belt to assure proper

fit and long life.

2. Reinstall gearcase belt keeper. Be sure the new drive

belt is inside the tabs of the gearcase belt keeper.

3. Position the blade adapter on the engine crank shaft.

Be sure key in adapter and crankshaft keyway are

aligned, and that the drive belt is inside the tabs of

the belt retainer.

4. Place rear baffle in mower housing.

5. Reinstall debris shield using screw.

6. Reinstall blade.

7. Return mower to upright po si tion.

8. Reinstall rear baffle screws.