Mowing Tips; To Empty Grass Catcher - Husqvarna HD775HW Operator's Manual

961430086
Hide thumbs Also See for HD775HW:
Table of Contents

Advertisement

TO START ENGINE
NOTE: Due to protective coatings on the engine, a small
amount of smoke may be present during the initial use of
the product and should be considered normal.
NOTE: Your engine is equipped with an automatic choke
system. No priming or choking is required before starting.
1. To start engine, hold operator presence control bar
down to the han dle and pull starter handle quickly.
Do not allow starter rope to snap back (Figure 14).
1
2
1. Operator presence control bar
2. Starter handle

TO EMPTY GRASS CATCHER

1. Lift up on grass catcher using the frame han dle
(Figure 15).
2. Remove grass catcher with clippings from under lawn
mower han dle.
3. Empty clippings from bag using both frame handle
and bag handle.
NOTE: Do not drag the bag when emptying; it will cause
unnecessary wear.
1
Figure 15
1. Bag handle
2. Grass catcher frame handle
OPERATION
Figure 14

MOWING TIPS

CAUTION:
attachments on your mower. Such attachments
are hazardous, will damage your mower and could
void your warranty.
Under certain conditions, such as very tall grass, it
may be nec es sary to raise the height of cut to reduce
pushing effort and to keep from overloading the engine
and leaving clumps of grass clippings. It may also be
necessary to re duce ground speed and/or run the
lawn mower over the area a sec ond time.
For extremely heavy cutting, re duce the width of cut
by over lap ping previously cut path and mow slowly.
For better grass bagging and most cutting conditions,
the engine speed should be set in the FAST po si tion.
When using a rear discharge lawn mower in moist,
heavy grass, clumps of cut grass may not enter the
grass catcher. Reduce ground speed (pushing speed)
and/or run the lawn mower over the area a second
time.
If a trail of clippings is left on the right side of a rear
discharge mow er, mow in a clockwise direction with
a small overlap to collect the clippings on the next
pass.
Pores in cloth grass catchers can become filled with
dirt and dust with use and catchers will collect less
grass. To prevent this, reg u lar ly hose catcher off with
water and let dry before using.
Keep top of engine around starter clear and clean of
grass clippings and chaff. This will help engine air flow
and extend engine life.
2
10
Do not use de-thatcher blade

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

961430086

Table of Contents