RIDGID RD80770 Operator's Manual page 10

ASSEMBLY
INSTALLING THE FRAME SUPPORTS
See Figure 3.
n Locate the frame supports, hex bolts ( long and  short),
and hex nuts.
n Raise the end of the pressure washer high enough to
access the frame bottom. Position blocks of wood under
the machine for support.
Align the hole on the frame support with holes on machine
n
frame.
Insert hex bolts through the hole in the machine frame
n
so that they pass through the frame support. Tighten the
bolts to the frame securely using hex nuts.
Repeat on other side.
n
INSTALLING THE PUMP OIL CAP
See Figure 4.
Remove and discard the cap securing the plastic bag to the
oil pump. Remove the cap from the bag.
To install the pump oil cap:
Screw the pump oil cap into the hole covering the
reservoir.
CAUTION:
Failure to install pump oil cap may result in
decreased pump life.
INSTALLING THE WAND STORAGE HOLSTER
See Figure 4.
Place key slots (on back of wand storage holster) over the
two bolts. Push the holster against the frame. When the bolts
are through the key slots, push the holster toward the floor.
Tighten the hex nuts.
lubricant
heX bOltS
(ShOrt)
heX bOltS
(lONG)
ASSEMBLING THE TRIGGER HANDLE
heX NutS
See Figure 5.
n Place
tor on the end of the trigger handle.
n Turn the connector clockwise until it stops. This
the spray wand in place.
n When not in use, remove the spray wand from the trig-
fraMe
ger handle by turning the connector counterclockwise.
SuppOrt
Store the unassembled spray wand in the wand
Fig. 3
holster.
10
key SlOtS
puMp
OIl cap
WARNING:
Make sure the nozzle and hose connections are
secure before starting the machine. A non-secured
accessory could become a projectile if not properly
installed which could result in serious injury.
the threaded end of the spray wand in the connec-
Fig. 4
secures
storage