Table of Contents
Advertisement
NaviTrack
Trouble Shooting Guide
PROBLEM
Receiver will not pick
up the line trans-
mitter's signal.
Unit will not power on.
Specifications
Power Source:
8 Alkaline or rechargeable batteries.(D-Cells)
Weight:
4.75 lbs (2.15 kg) w/o batteries
7.5 lbs (3.4 kg) w/batteries
Cable Length:
Dimensions:
Depth ..................... 7.0" (17.7 cm)
Width ..................... 15" (38.1 cm)
Height .................... 6.5" (16.5 cm)
Output Power:
Nominal 10 watts maximum if under 45kHz,
1 watt maximum if frequency is above 45kHz.
Power Settings:
Ridge Tool Company
®
Line Transmitter
PROBABLE FAULT LOCATION
Check that the correct frequency is selected, and that the transmitter is the correct
mode (direct-connect/inductive).
Make sure that the leads to line and to the ground are attached securely
Too much resistance impeding current flow. Improve ground connection by deepening
stake, moistening ground, or relocating stake. Improve circuit by relocating transmitter
on line.
Increase power output.
European Models: If using 93 kHz setting, try using the alternative 93 kHz frequency.
See page 9 for instructions on the use of these frequencies.
Check orientation of batteries.
Check that the batteries are charged.
Check to see that the battery contacts are OK.
25' (8m)extended
~3 feet (1m) contracted
4 mA
15 mA
50 mA
150 mA
600 mA
Elyria, Ohio
Standard Replacement Parts
A. Direct Connect Lead (25' (8m) (Cat # 18423)
B. Battery Holder Cover Assembly (Cat # 18428)
C. Battery Holder (Cat # 18433)
D. Ground Spike (Cat # 18438)
E. Direct Connect Lead Clip (Cat # 18443)
F. (Optional) Inductive Clamp (Cat # 20503)
U.S.A
www.navitrack.com
17
Advertisement
Table of Contents
