RIDGID JP06101 Operator's Manual page 15

ASSEMBLY
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in acciden-
tal starting and possible serious personal injury.
ASSEMBLING SIDE PANELS AND MOTOR
MOUNT
See Figures 10 - 11.
n Locate the following:
Carriage Head Bolts (6), 5/16-18 x 1/2 in.
Serrated Flange Hex Nut (6), 5/16 in.
Left Panel Side (1)
Right Panel Side (1)
Motor Mount (1)
n Mount the motor mount onto the left side panel as shown.
Make sure the lower tab of the motor mount with two
holes is on the inside of the left side panel. Bolt the motor
mount to the panel using the 5/16 in. carriage head bolts
and 5/16 in. serrated flange nuts. Tighten the nuts with a
wrench.
NOTE: Make sure that the tabs of the motor mount panel
are on top of the left side panel tabs.
n Mount the right side panel to the motor mount as shown
using 5/16 in. carriage head bolts and 5/16 in. serrated
flange nuts. Tighten the nuts with a wrench.
ASSEMBLING FRONT PANEL
See Figure 12.
n Locate the following:
Carriage Head Bolts (6), 5/16-18 x 1/2 in.
Serrated Flange Hex Nuts (6), 5/16 in.
Front panel with RIDGID logo (1)
NOTE: Tabs on front panel must be on the inside of side
panel prior to securing with nuts and bolts.
n Bolt the front panel in place as shown using 5/16 in. car-
riage head bolts and 5/16 in. serrated flange nuts. Make
sure the front panel is mounted on the same side of the
base as the switch opening. The panel should bolt in
place on the backside of the left and right side panels as
shown. Tighten the nuts with a wrench.
n Tighten all bolts on the base at this time.
NOTE: It may be easier to tighten the bolt holding the
front panel on if the base is turned upside down. The rear
panel will be mounted later.
NOTE: Holes marked "A" on both front and rear panels
are not used for assembly.
CARRIAGE
BOLT
FLANGE
HEX NUT
FLANGE
HEX NUT
"A"
CARRIAGE
BOLT
FRONT
PANEL
15
MOTOR
MOUNT
LEFT SIDE
PANEL
Fig. 10
CARRIAGE
BOLT
RIGHT SIDE
PANEL
Fig. 11
SWITCH
OPENING
Fig. 12