Clip Director - Honda HRR216VKA Owner's Manual

®

Clip Director

The Clip Director can be adjusted to either the BAG or MULCH
position to achieve the desired mowing results.
Adjust the Clip Director lever to
either the bag (shutter door fully
open) or mulch (shutter door
fully closed).
To adjust the Clip Director, push
the end of the lever and twist the
lever to the desired position.
Release the button and allow it
to snap into the groove.
Mulching
Set the clip director lever in the MULCH position.
SHUTTER DOOR
(fully closed)
Some grass accumulation in the discharge opening is normal when
the Clip Director is in the MULCH position. To remove this grass,
close the discharge guard, set the Clip Director to the BAG position,
engage the blade control lever, and start the engine.
If the Clip Director is difficult to move or the lever will not lock fully:
• With the engine OFF, lift the discharge guard and remove the grass
clippings from around the shutter door.
• With a garden hose and nozzle, spray around and under the Clip
Director lever and cover assembly to remove the grass clippings.
PUSH AND TWIST
CLIP DIRECTOR LEVER
AND COVER ASSEMBLY
Bag or Rear Discharge
Set the clip director lever in the BAG position.
SHUTTER DOOR
(fully open)
To discharge clippings to the rear, remove the grass bag and leave
the Clip Director lever in the BAG position.
Rear Shield
During normal use the rear shield is subject to deterioration and wear.
Remove the grass bag and raise the discharge guard to check the
rear shield for cracks or tears. If the rear shield is excessively worn,
have it replaced by your authorized Honda servicing dealer.
CLIP DIRECTOR LEVER
AND COVER ASSEMBLY
DISCHARGE GUARD
REAR SHIELD
5