Plug and Receptacle
(models without electric starter)
BATTERY
To prepare the outboard motor for
connection to a battery, pull the cover
out of the DC receptacle, connect
your battery charging wires to the
receptacle. Attach the connected DC
receptacle on the holder on the tiller
arm.
The receptacle is provided with a
cover, which should be attached
when the plug is removed, in order to
keep the receptacle clean and dry.
T
T
O
O
B
B
A
A
T
T
TO ACCESSORIES
Battery
For complete information, refer to
the battery manufacturer's
instructions.
Minimum Requirements
12V-35Ah (27 CCA)
T
T
E
E
R
R
Y
Y
DC RECEPTACLE
COVER
INSTALLATION
Battery Terminals
(
) TERMINAL
(
) TERMINAL
BLACK or GREEN
Connect the positive (+) battery cable
to the positive (+) battery terminal,
then connect the negative (-) battery
cable to the negative (-) battery
terminal.
The negative (-) battery cable should
always be removed from the battery
when connecting or disconnecting
the positive (+) battery cable, so tools
cannot cause a short circuit if they
touch a grounded part while being
used on the positive (+) battery
terminal fitting.
RED
31