CONTROLS AND FEATURES
Transom Angle Adjusting Rod
The transom angle adjusting rod is
used to adjust the angle of the out-
board motor in the normal operating
position (see page 21).
To adjust, first tilt the outboard mo-
tor, so it is not resting on the rod.
Push the rod in, and turn the end of
the rod up, so the latch will fall into
the line with the rod.
Remove the rod, and reinsert it in
the desired.
Remove the rod in, and turn the end
of the rod down, so the latch will fall
to the locked position. Then release
the rod.
Engine Cover Lock Lever
The engine cover lock lever fastens
the cover to the outboard motor.
To remove the cover, move the
lever to the unlocked position, then
lift off the cover.
To install the cover, position the
cover on the outboard motor, then
move the lever to the locked posi-
tion.
16
TRANSOM ANGLE
ADJUSTING ROD
TO REMOVE
TO LOCK
ENGINE COVER LOCK LEVER
LOCKED
UNLOCKED
(UNLOCKED)
LATCH
(LOCKED)