Seat Adjustment; Ground Speed Control Lever Adjustment; Speed Balancing Adjustment - Ferris 5900621 Operator's Manual

SEAT ADJUSTMENT

See Figure 31. The seat can be adjusted fore and
aft. Move the lever forward, position the seat as
desired, and release the lever to lock the seat into
position.
GROUND SPEED CONTROL LEVER
ADJUSTMENT
The control levers can be adjusted in three ways. The
alignment of the control levers, the placement of the
levers (how close the ends are to one another) and
the height of the levers can be adjusted.
Handle Alignment
Loosen the mount hardware (A, Figure 32) and pivot
the lever(s) (C, Figure 32) fore or aft to align with
each other.
Handle Placement
Loosen the jam nuts and adjust the placement bolt
(B, Figure 32) in or out to properly adjust the lever
end spacing.
Handle Height
Remove the mounting hardware (A, Figure 32) and
reposition the handle either up or down from its
original position. You will need to readjust the handle
alignment as described above.

SPEED BALANCING ADJUSTMENT

If the rider veers to the right or left when the ground
speed control levers are in the maximum forward
position, the top speed of each of these levers can be
balanced by turning the adjustment bolt(s) (A, Figure
33). Only adjust the speed of the wheel that is
traveling faster.
To Reduce the Speed of the Faster Wheel
1. Loosen the flange nuts.
2. turn the top speed adjustment bolt COUNTER-
CLOCKWISE to reduce the speed.
3. Retighten the flange nuts when adjustment is
complete.
WARNING
DO NOT adjust the tractor for a faster overall
speed forward or reverse than it was designed
for.
Troubleshooting, Adjustment & Service
Seat
Adjustment
Lever
Figure 31. Seat Adjustment
C
B
Figure 32. Control Lever Adjustment
A. Alignment Hardware
B. Placement Hardware
C. Ground Speed Control Lever
Figure 33. Top Speed Adjustment
A. Top Speed Adjustment Bolt
B. Flange Nut
A
A
B
41