Base Stand Assembly Instructions; Remote Control Installing Batteries - Haier L40F1180 Owner's Manual

4. Base Stand Assembly Instructions

Parts
needed for base stand assembly
Rear cabinet of TV
TV stand
Screws:4 x B4 x 16 (supplied)

5. Remote Control Installing Batteries

1). Open the battery compartment cover on the back of the remote control.
2). Insert two 1.5V AAA size batteries observing the polarity markings inside the battery
compartment. Don't mix di
3). Close the cover.
Batteries shall not be exposed to excessive heat such as direct sunlight or fire.
- The remote control should be operated within 30 feet (7m) and 30
IR receiver at the front of the TV.
- Used batteries should be disposed of properly
Step 1
Battery
Compartment
Cover
Installation
(Gently place the TV face down on a soft, flat surface, such as a blanket,
foam, or cloth.)
1. Put the stand on the TV set
2. Screw the stand in the positions with the screws supplied (4 x B4 x 16).
fferent types or used batteries with new ones.
Step 2
2 x AAA Battery
Note: the pictures below are only for reference
0
to the left and right of the
Introduction
Screws: 4xB4x16
Step 3
9