Fender P/N 051923 Owner's Manual page 9

RUNNING AN EFFECTS PROCESSOR THRU YOUR LTB
1. Connect speakers, microphones and other
equipment to the LTB as before.
2. Next, connect a cord from the EFX jack to the input
on the effects processing unit. Return the signal to
the LTB by connecting a cord from the output of the
effects unit to the AUX IN jack on the LTB.
Volume Value
1 2 3 4 5 6 7 8
Value Value Value Value Value Value Value Value Yes
This Illustration was done
A B
by Phil Sanchez
Value Value
January 27, 1997
No
3. The EFX knob on each channel adjusts the
amount of signal sent to the EFX jack where the
signal is then sent to the processor.
4. Be sure to turn on the tape deck, keyboard or
other instruments and outboard gear before
powering up the LTB.
9