Choice Of Player Location; Power Connection - Goldmund SRCD3 User Manual

2 SETTING UP THE SRCD3
2.3

CHOICE OF PLAYER LOCATION

Due to the specific quality of its Goldmund "Mechanical Grounding" construction, the
Goldmund Player is less critical than other designs in placement selection. Feedback is
mostly so low that no special precaution is required. Nevertheless, position the player as far
as you can from all speakers if you want to totally avoid the air coupling between the
speakers and the player.
Locate the player on a support providing the most rigid possible connection to the floor.
Solid coupling is essential, and if your support is standing on a suspended floor, at least one
foot should be located over a supporting beam or close to a supporting wall for an optimal
result.
2.4

POWER CONNECTION

Plug the AC power cord into the back of the SRCD3 and in a wall socket. Switch the back
power switch ON and press STANDBY/ON on the remote control to switch the player on.
You can also use the OPEN/CLOSE button to switch on the player and open the disc tray at
the same time.
When first activated the system will take a few seconds to load and verify all settings before
illuminating the display. This delay is normal. On completion, the front display will be
illuminated as you press any key or when pressing the remote control STANDBY/ON button,
meaning the unit is now powered on.
This player features a screen saver. If the player is stopped or paused and no button is
pressed for five minutes, the screen saver starts.
User manual – Goldmund SRCD3 CD/SACD Player
P5