Fujitsu Inverter Halcyon ASU9RL Operating Manual page 15

Air Cleaning Filter Installation
1. Open the Intake Grille and remove the Air
filters.
2. Attach the air cleaning filter to the frame
of the front panel.
G Attach the filter on the inside of the tabs (6 places) so
as not to stick out.
Air cleaning filter frame
Tabs (6 places)
(In the above figure, the intake grille is omitted for
the explanation)
3. Install the two Air filters and close the
Intake Grille.
G Don't operate the air conditioner with being opened
the intake grille.
G When air cleaning filters are used, the effect will increased
by setting the fan speed to "High".
Replacing dirty Air cleaning filters
Replace filters with the following components (purchased
separately).
G POLYPHENOL CATECHIN AIR CLEANING FILTER : UTR-FA16
G Negative air ions deodorizing filter: UTR-FA16-2
1. Open the Intake Grille and remove the Air
filters.
Air filter
Tabs
(6 places)
2. Remove the air cleaning filters attached
to the frames of the front panel.
Air cleaning filter frame
3. Replace them by two new Air cleaning
filters.
1 Remove the old air cleaning filters in reverse order of
their installation.
2 Install in the same way as for installation of the air
cleaning filter set.
4. Install the two Air filters and close the
Intake Grille.
G Don't operate the air conditioner with being opened
the intake grille.
About the Air Cleaning Filters
POLYPHENOL CATECHIN AIR CLEANING FILTER (one sheet)
G The Air Cleaning Filters are disposable filters. (They can
not be washed and reused.)
G For storage of the Air Cleaning Filters, use the filters as
soon as possible after opening the package.
(The air cleaning effect decreases when the filters are left
in the opened package)
G Generally, the filters should be exchanged about every
three months.
Please buy designed air cleaning filters (UTR-FA16) (Sold
separately) to exchange the used dirty air cleaning filter.
[Negative air ions deodorizing filter (one sheet) — light blue]
G The filter should be exchanged about every three years
so as to maintain the deodorizing effect.
G Filter frame is not a one-off product.
Please buy designed deodorizing filter (UTR-FA16-2) (Sold
separately) when exchanging the filter.
Maintenance of Deodorizing Filters
In order to maintain the deodorizing effect, please clean the
filter in the follow way once three months.
1 Remove the deodorizing filter.
2 Clean with water and dry in the air.
1) Flush the filter with high-pressure hot water until
the surface of the filter is covered with water. Please
flush with diluent neutral detergent.
Never wash by reaming or rubbing, otherwise it
will damage the deodorizing effect.
2) Rinse with water flow.
3) Dry in shade.
3 Reinstall the deodorizing filter.
Air filter
En-14