Input / Output Connections; Basic Setup Of Your Srm 6302 / 8302 - Fender SRM 6302 Owner's Manual

INPUT / OUTPUT CONNECTIONS

The SRM 6302 / 8302 has a variety of
connectors on its input / output panels.
Below is a chart listing the various types
and their pin outs.
Jack Style Connection
MIC XLR Balanced
INPUTS Female
LINE 1/4" Balanced
INPUTS TRS
MAIN, 1/4" TS Unbalanced
MONITOR,
EFFECTS
OUTPUTS
FOOT 1/4" TS
SWITCH
PA 1, 1/4" TS Unbalanced
PA 2,
EFFECTS
INPUTS
TAPE Dual Unbalanced
IN / OUT RCA
PA 1, 1/4" TS Speaker
PA 2
OUT
Pin Out
Pin 1 = GND
Input Pin 2 = POS
Pin 3 = NEG
Tip = POS Signal
Input Ring = NEG Signal
Sleeve = GND
Tip = Signal Output
Output Sleeve = GND
Switch Tip = Signal
Sleeve = GND
Tip = Input Signal
Input Sleeve = GND
Inner Ring = Signal
Input / Outer Shell = GND
Output
Tip = Signal
Output Sleeve = GND

BASIC SETUP OF YOUR SRM 6302 / 8302

Before using the SRM 6302 / 8302,
please read and follow the steps listed
below:
1. IMPORTANT Heed all safety warnings when
operating the SRM 6302 / 8302.
2. Make sure the power switch is in the OFF position
and all volume levels are in the 0 position.
3. Next, plug the supply cord into a power source
with the correct voltage.
5. Connect the speaker cables from the SRM 6302 /
8302 PA out jacks to the input jacks of the speaker
cabinets.
6. Connect the cord(s) from any outboard gear,
microphones or other signal source(s) to the
appropriate input jack(s) on your SRM 6302 /
8302's.
7. First, turn all outboard gear, instruments and other
equipment ON, then the SRM 6302 / 8302.
8. Increase volume controls and effects level controls
to their desired levels, listening for feedback or
ringing.
9. When shutting down the SRM 6302 / 8302, turn
OFF the SRM 6302 / 8302 first then any additional
outboard gear, instruments or other equipment.
For more detail on setting up your SRM 6302 / 8302,
please refer to the diagrams on pages 10 thru 13.
8