Running An Effects Processor Thru Your Srm 6302 / 8302 - Fender SRM 6302 Owner's Manual

RUNNING AN EFFECTS PROCESSOR THRU YOUR SRM 6302 / 8302

1. Connect speakers, microphones and other
equipment to the SRM 6302 / 8302 as before.
2. Next, connect a cord from the Effects
Out/Footswitch jack to the input of the effects
processing unit. Return the signal to the SRM 6302 /
8302 by connecting a cord from the output of the
effects unit to the Effects In jack on the SRM. (When
PA 2 is assigned to the main front of house
enclosures, be sure one enclosure is connected to a
PA 1 Out jack and the other is connected to a PA 2
Out jack.)
3. The Effects control in each channel strip adjusts
the amount of signal sent to the reverb / effects bus
where all the effects signals from the channels are
summed. The Effects control in the master section
adjusts the signal level to the effects processing unit
and the reverb pan.
4. Be sure to turn on the tape deck, keyboard or
other instruments and outboard gear before
powering up the SRM 6302 / 8302.
11