Generator Features - Powermate PM0123250 Operator's Manual

A. Control Panel
NOTE: Total power drawn from all receptacles must not exceed
the nameplate ratings.
B. 120 V, 20 Ampere Receptacle
20 amps of current may be drawn from the receptacle.
However, total power drawn must be kept within nameplate
ratings.
C. 120/240 V, 20 Ampere Twistlock Receptacle
Maximum full load current may be drawn from the
120/240 volt receptacle, provided it is the only receptacle
used. Total current must be limited to the nameplate rating.
If the 120/240 volt receptacle is used along with the 120 volt
receptacle, the total load drawn must not exceed the nameplate
ratings.
D. Receptacle Covers
E. Circuit Protectors
The receptacles are protected by an AC circuit protector. If the
generator is overloaded or an external short circuit occurs, the circuit
protector will trip. If this occurs, disconnect all electrical loads and
try to determine the cause of the problem before attempting to use the
generator again. If overloading causes the circuit protector to trip,
reduce the load. NOTE: Continuous tripping of the circuit
protector may cause damage to generator or equipment. The
circuit protector may be reset by pushing the button of the protector.
F. Slide-Out Quick Instruction Card
G. Ground Terminal
A
H
G
D
E
L
F
English
GENERA
GENERA
E
B
I
S
K
J
T
T OR FEA TURES
T OR FEA TURES
H. Hour Meter
• Press and release mode button to toggle between Total Timer
and Timer 1 (TMR1).
• Total Timer displays and records the total hours your
generator has run. Total Timer is not resettable.
• Timer 1 can be used to track operating hours for service
intervals. Timer 1 is resettable by holding the mode button
down for 3 seconds while TMR1 is displayed.
I. Engine On/Off Switch
J. 208 CC OHV Engine
K. Recoil Starter
L. Engine Choke Lever
M. Oil Filler Cap
N. Oil Drain Plug
O. 5 Gallon Metal Fuel Tank
P. Fuel Tank Cap
Q. Fuel Gauge
R. Fuel Shut-Off Valve
S. Air Filter
T. Folding Handle
Q
C
P
N M
R
6
O
Customer Hotline 1-800-445-1805