To Select A Source; Source Identification - Zenith SYSTEM 3 Series Operating Manual And Warranty

SOURCE MENU
_ SOURCE MENU "---1
-_ ANT/CABLE
VIDEO 1
VIDEO 2
SOURCE MENU
-_ PIP SOURCES ---i
ANTICABLE
-> VIDEO 1
PIP SOURCES appears while PIP is active
TO SELECT A SOURCE
You select the source you want by selecting the SOURCE
MENU. It shows the possible sources available for your
viewing selection.
To Access the SOURCE MENU Directly
1. Press SOURCE on the remote control to bring up
the SOURCE MENU.
2. Press SOURCE repeatedly until the source you
want is highlighted.
3. Press ENTER (ENT) to return to normal viewing.
To Access the SOURCE MENU Indirectly
1. SOURCE MENU should be selected if you followed
the "Basic Menu Operation" given in the "On-
Screen Menus" section.
2. Press SELECT (SEL) Up/Down until the desired
source is highlighted.
3. Press ENTER (ENT) to return to normal viewing.
SOURCE IDENTIFICATION
The Channe!/Time display is used to determine the input
source currently being viewed. To see the Channe!/Time dis-
play, press ENTER (ENT). If an antenna or cable-TV
source is being viewed, the Channel/Time display is shown
in the Channel Number/Time format. If a VIDEO 1 or
VIDEO 2 source is being viewed, the Channel!Time display
shows VIDEO 1 or VIDEO 2.
NOTE: The sources are identified by color in both the dis-
plays and on the connection center on the back of the TV.
The color for the Channel/Time display, Volume and
Muted display will match the color for the source you are
watching.
SOURCE EQUIPMENT CONNECTIONS
The actual source selected for viewing on your TV depends
on how the TV is connected to external equipment.
Selecting ANT/CABLE from the SOURCE MENU: Routes
the ANTENNA/CABLE source to the TV for viewing. You
see program material from the signal source that is con-
nected to the ANTENNA/CABLE jack. Usually the anten-
na is connected to the ANTENNA/CABLE jack. In cable
applications, the output from a cable-TV decoder is con-
nected to this jack. For VCR application, the ANT OUT
from the VCR is connected to this jack.
Selecting VIDEO 1 or 2 from SOURCE MENU: Routes the
video source output (such as a VCR or a Video Disc
player) to the TV for viewing. These video sources must be
connected to corresponding VIDEO 1 or VIDEO 2 jacks.
Select ANT/CABLE for
source connected to
ANTENNA/CABLE jack
Select VIDEO ] or
VIDEO 2 for sources
connected to VIDEO ]
or VIDEO 2 jacks
V
ANTENNA/CABLE I I
-@.
o
v
I
D2
E
O
:i RtGHT LEF_
©©©
SURROUND V._I_IABLE AUDIO
SPEAKER OUTPUT
EXT _ INT
SPEAXER
RIGHT LEFT
©©©
©©©
VIDEO AUDIO
Connection Center on Back of TV
2577.B 7 -- 1