Signal Info; Standby Charge - Yamaha RX-V471 Owner's Manual

Signal Info
Displays information on the current video and audio signals.
Input sources
HDMI1-4, AVl-4, and tile input source set as a TV audio input when ARC is used
Items
Format Audio signal format.
When this unit is unable to detect a digital signal, it automatically
(FORMAT) switches to an analog input.
Channel
(CHAN)
The number of source channels in the input signal (front/surround/
LFE).
For example, "3/2/0.1" means 3 front channels, 2 surround channels
and LFE.
If a channel that cannot be expressed as the above, a total number of
channels such as "5.1ch" may be displayed.
Sampling The number of samples taken per second when converting an analog
(SAMPL) signal into a digital signal.
Bitrate
The number of bits passing a given point per second.
(B RATE)
Input
Video input signal format
(V IN)
Output
Video output signal format.
(V OUT)
Error messages about HDMI. This item appears only when error
concerning HDMI occurs.
Message
(V MSG)
HDCP Error (HDCP Error):
The connected TV is not compliant to the High-bandwidth Digital
Content Protection (HDCP). Make sure that the HDCP compliant TV is
connected.
Device Over (Device Over):
The number of devices connected to HDMI OUT jack exceeded the
limitation. Reduce the number of the connected devices.
Procedure to switch the items on the front display.
Press the cursor keys (A/_7) to switch the display of information on the front display.
Selected item Signal information
Front display
Standby Charge
Sets whether or not to charge an iPod connected to the iPod dock or iPod wireless
audio receiver while the unit is in standby mode.
Input sources
DOCK (iPod)
Settings
On (Default) Charges iPod when the unit is in standby mode.
Off Does not charge iPod when the unit is in standby mode.
• When iPod is connected to the unit with a USB cable, iPod cannot be charged while the unit is in standby
mode.
• The list of all signal information is displayed on a TV monitor.
En 58