Before You Call - Electrolux WRS26MR4JW6 Use & Care Manual

Table of Contents

Advertisement

1-800-944-9044
(United States)
1-800-265-8352
(Canada)
Visit our web site at
www.frig idai re .com.
P.OBLE.[
C, U SE
[
CO..ECTION
AUTOMATIC
ICE MAKER
Ice maker
is not mak-
Ice maker wire signal arm is in
ing any ice.
the "up" or OFF position.
Ice maker power switch is Off.
Ice maker has small cube
caught in mechanism.
Saddle valve on cold water
pipe is clogged or restricted by
foreign material.
Ice maker
is not mak,
ing enough
ice,
than you expect
Check to see if water dispenser
is dispensing slower than normal.
Ice maker
will not stop
Ice maker wire signal arm is
making
ice.
being held down by some item
in the freezer.
0
Ice cubes are not be!ng used
frequently enough.
. :ice
cubes are hollow (partially
frozen cubes with water inside),
Tee cubes are freezing
together,
Freezer control is set too warm:
,,
Hove wire signal arm to the "down" or ON position. (side
mounted)
Turn power switch to On CT") position. (rear mounted)
Remove small cube from ice maker. The ice and water
filter cartridge may be clogged.
Replace filter cartridge.
Turn off household water line valve. Remove valve. En-
sure that valve is not a self-piercing saddle valve. Clean
valve. Replace valve if necessary.
0
Side mounted _should
pr0duce 4to 4,5 p0unds--
(approximately
4 quarts)of
ice every 24 hours: A rear
mounted ice maker should produce 3 to 4 pounds (ap-
proximately 31/2 quarts) of ice every 24 hours, Quick
Ice option should produce up to 50% more ice eVerY 24
hours,
:if it is, replace the ice and water filter cartridge.
Move item and release wire signal arm. Remove any ice
cubes that are frozen together over the wire signal arm.
,
Remove ice container and discard ice from container.
Ice
maker wi!l Pr0duce fresh supply,
*
The ice and water filter cartridge may be clogged. Re,
place f!!ter cartridge.
o
Set freezer control to colder seLLing.Allow
24 hours
temperature to stabilize.
ICE DISPENSER
DiSpenser
will
not dis'
*
storage Container is empty.
pease ice,
Freezer temperature
is set too
,
ice dispensingarm has been heid
in for more than 4-5 minutes.
Ice dispenser
is
jammed,
Ice has melted and frozen
around auger due to infrequent
use, temperature
fluctuations,
and/or power outages.
Ice cubes are jammed between
ice maker and back of ice
container.
,
When the first supPlY of ice is dropPed into the container,
the dispenser should operate.
freezer control to a higher seLLing so that ice cubes
wi!l be made.
When first supply of ce iS made)dispenser
should operate.
Open househo
d water I neva ve
A ow suffic entt me
for
the ice to be madel
When ice iS made, the dispenser
should operate:
......
Motor is overloaded,
Motor over load protector
will reset
in
approximately
3 minutes:
:Ice can then be dispensed:
,,
Remove ice container, thaw, and empty the contents.
Clean container, wipe dry, and replace in proper position.
When new ice is made, dispenser should operate.
,,
Remove ice cubes that are jamming the dispenser.
OPENING/CLOSING
OF DOORS/DRAWERS
Door(s)
will not close.
Door was closed too hard, caus-
ing other door to open slightly.
Refrigerator is not level. It
rocks on the floor when moved
slightly.
Refrigerator is touching a wall
or cabinet.
Drawers are difficult
to
0
Fo0d is t0uching shelf 0n t0p 0f
move:
drawer.
Track that drawers slide on is
Close both doors gently.
Ensure floor is level and solid, and can adequately sup-
port the refrigerator.
Contact a carpenter to correct a
sagging or sloping floor.
Ensure floor is level and solid, and can adequately sup-
port the refrigerator.
Contact a carpenter to correct a
sagging or sloping floor.
Remove top !aYer of items in drawer.
Ensure drawer is properly installed on track.
Clean drawer, rollers, and track.
See Care &Cleaning:
dirty.
17

Advertisement

Table of Contents
loading

Table of Contents