Table of Contents
Advertisement
Coil e lements should belevel foroptimal cooking r esults. Burner
bowls, when clean, reflect heat b ack tothecookware. They also
help catch spills.
Cookware should notextend m ore than1in.(2.5 cm)over t he
coilelement. Ifcookware isuneven ortoolarge, itcanproduce
excess h eat c ausing theburner bowl t ochange c olor. Formore
information,
see the"General Cleaning" section.
Before r emoving orreplacing coil e lements andburner bowls,
make sure they arecool a ndthecontrol knobs a reintheoff
position.
To
Remove:
1. Push in the edge of coil element toward the receptacle. Then
lift it just enough to clear the burner bowl.
/
The lift-up cooktop provides easy access for cleaning beneath.
Be careful not to drop the cooktop.
Damage could occur to the
finish and the cooktop frame. For more information, see the
"General Cleaning" section.
To Lift:
1. Lift the cooktop by both front corners until the supports lock
into place.
2. Pull the coil element straight away from the receptacle.
To Replace:
1. Lift the cooktop from both sides while pressing the support
rods back to unlock them.
2. Slowly lower the cooktop into place.
3. Lift out the burner bowl.
To Replace:
1. Line up openings in the burner bowl with the coil element
receptacle.
\
2. Holding the coil element as level as possible, carefully push
coil element terminal into the receptacle.
3. When the terminal is pushed into the receptacle as far as it
will go, push down the edge of the coil element opposite the
receptacle.
When canning for long periods, alternate the use of surface
cooking areas, elements or surface burners between batches.
This allows time for the most recently used areas to cool.
•
Center the canner on the grate or largest surface cooking
area or element. Canners should not extend more than 1 in.
(2.5 cm) outside the cooking area.
•
Do not place canner on two surface cooking areas, elements
or surface burners at the same time.
•
On ceramic glass models, only use flat-bottomed
canners.
•
On coil element models, the installation of a Canning Unit Kit
is recommended.
If a kit is not installed, the life of the coil
element will be shortened. See "Assistance
or Service" for
ordering instructions.
•
For more information, contact your local U.S. Government
Agricultural Department Extension Office. In Canada, contact
Agriculture Canada. Companies that manufacture home
canning products can also offer assistance.
8
Hide quick links:
Advertisement
Table of Contents
