Whirlpool Duet WFW9400VE03 Use & Care Manual page 22

Table of Contents

Advertisement

Available languages

Available languages

Washer won't drain or spin
[]
is the drain hose kinked? is the drain hose clogged,
or the
end of the drain hose more than 96" (2.4 m} above the
floor?
[]
Is your voltage
low?
Check electrical source or call electrician.
Do not use an
extension cord.
[]
Is the "SUD" routine
active?
Cycle will complete once extra suds are removed.
[]
is the load balanced?
A single or bulky item may cause imbalance. Add more items
or redistribute the load.
Washer
makes
noise or vibrates
[]
is the washer level?
The washer must be level. The four feet should be properly
installed, and the nuts should be tightened against the
washer cabinet.
[]
Is the washer gurgling
or humming?
As water is drained from the washer, you may hear air being
pulled through the pump. This happens during the end of
draining, it is normal.
[]
Are you washing
items with metal snaps, buckles,
or zippers?
You may hear metal items touching the washer drum.
This is normal.
[]
is washer installed on a sturdy and solid floor?
Refer to the "installation instructions" for flooring
requirements.
Noise and vibration may be reduced by
securing a piece of 3/4"(19.1 ram) plywood underneath your
washer. The plywood may extend underneath both washer
and dryer to keep them at equal heights.
Washer
leaks
[]
Check household plumbing for leaks.
[]
Are the inlet hose connections
tight?
For inlet hose connections,
see "Connect the inlet Hoses."
Dispensers
clogged
or leaking
[]
Are the laundry products in the correct
dispenser
compartment?
Add the correct amounts of detergent, fabric softener, or
liquid chlorine bleach to the correct compartments.
Add
powdered or liquid color-safe bleach to the Main Wash
compartment.
Be sure to match powdered color-safe bleach
with powdered detergent or match liquid color-safe bleach
with liquid detergent.
[]
is the detergent
type selector
in the correct
position?
Selector should be in the lowered position when using liquid
detergent and in the upper position when using powdered
detergent. See "Cleaning the dispenser drawer" in the
"Cleaning Your Washer" section.
Washer
odor
_HHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHH_
[]
See "Cleaning
Your Washer."
[]
Are you using AFFRESH
TM
washer cleaner on a regular
basis?
AFFRESH
TM
washer cleaner removes and avoids odor-causing
residue in all High Efficiency washers. For washers where odor
is present, use 3 tablets instead of 1 tablet. After the CLEAN
WASHER cycle is complete, wipe away residue if necessary.
[]
Are you using HE detergent?
Use of non-HE detergent can cause a film residue which can
result in odor.
Did you leave the door open after use?
This washer has a tight seal to avoid water leaks. To avoid
odors, leave the door open to allow the washer to dry
between uses.
Load too wet
[]
Did you use the right cycle for the load being washed?
Select a cycle with a higher spin speed.
[]
Did you wash a single item or bulky items or have you
overloaded
the washer?
A single item, bulky items, or overloading
may cause
imbalance. Add items or try to evenly distribute your wet
laundry in the drum, and start a DRAIN/SPIN cycle, if the
laundry is still wet, take half of the load out of the washer
and try again.
Residue or lint on load
[]
Did you add detergent
to the dispenser?
For best results, add detergent to the detergent
compartment.
Do not add detergent to the washer drum.
[]
Did you sort properly?
Sort lint givers (towels, chenille) from lint takers (corduroy,
synthetics). Also sort by color.
[]
Did you overload
the washer?
Do not overload the washer. The washer can be fully loaded,
but not tightly packed. The wash load must be balanced. Lint
can be trapped in the load if the washer is overloaded.
[]
Check the following:
Was paper or tissue left in pockets?
[]
Did you use enough HE detergent?
Use enough detergent to remove lint and hold it in
suspension. Use only HE detergent. Follow the
manufacturer's
instructions
to determine the amount
of detergent to use.
[]
is your water colder than 6O°F (15.6°C)?
Wash water colder than 60°F (15.6°C) may not completely
dissolve the detergent.
[]
Are you using a low=speed wash cycle?
Powdered detergents may not dissolve well in a slow-speed
cycle. For best results, use liquid detergent for slow-speed
cycles such as Delicate, Hand Washables, Silk and Wool.
22

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents