Table of Contents
Advertisement
INSTALLATION
INSTRUCTIONS
Before
you begin
operating
the oven, carefully
read the following
instructions.
1. Empty the microwave oven. Clean the inside with
a soft, clamp cloth. Check for damage such as a
door that isn't lined up correctly, damage around
the door, or dents inside the oven or on the
exterior. If there is any damage, do not operate the
oven until a designated service technician
has
checked it and made any needed repairs.
2. Put the oven on a cart, counter, table, or shelf that is
strong enough to hold the oven and the food and
utensils you put in it. (The control side of the unit
is the heavy side. Use care when handling the
oven.) The weight of the oven is about 55 Ibs
(25 kg). The microwave oven should be at a
temperature above 50°F (10°C) for proper operation.
NOTE: You can build your microwave oven into a
wall or cabinet by using one of the trim kits listed in
the "Built-in kits" section.
ooooooooooooooo
0°%%%%%%%%%%%%%%%%
%%%_%%%%%%%%%%%%%%
%%%%%%%%%%%%%%%%%%
%%%%%%°%%%q_%%%%%
%_%%%o
%%%%%%%%%
%%%%%
0%%%%%%%%
®
Air intake
Exhaust vent
Power
opening
(in rear)
supply cord
(in rear)
NOTE: Do not block the exhaust vents or air intake
openings. Allow a few inches of space at the back of
the oven where the exhaust vents are located.
Blocking the exhaust vents could cause damage to
the oven and poor cooking results. Make sure the
microwave oven legs are in place to ensure proper
airflow. If vents are blocked, a sensitive thermal safety
device may automatically
turn the oven off. The oven
should work properly once it has cooled.
Observe all governing codes and ordinances. A 120
Volt, 60 Hz, AC only, 15- or 20-amp fused electrical
supply is required. (A time-delay fuse is
recommended.)
It is recommended
that a separate
circuit serving only this appliance be provided.
Fire Hazard
Do not install the oven next to or over a heat
source without a UL approved trim kit.
Doing so can result in death, fire,
or electrical shock.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
Advertisement
Table of Contents
