Set-Up; Capabilities; Important Safety Instructions; Operation - Fellowes HD-10CS User Manual

Safe Sense™ Technology (yellow)
Shredder head
Paper entry
Bin full indicator
Mesh basket
Breakthrough Safety Technology! SafeSense™ stops shredding when hands are too close to the opening.

SET-UP

— To Test SafeSense
Place head on basket
as shown: Press Auto-On ( )

CAPABILITIES

Will shred: Paper, small paper clips, credit cards and staples
Will not shred: Continuous forms, adhesive labels, transparencies, newspaper,
cardboard, large paper clips, laminates or plastic other than
noted above
Paper shred size:
Confetti-Cut ..................................................................... 5/32" x 2" (3.9 x 50mm)
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Keep away from children and pets. Keep hands away from paper
entry. Always unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc.– away
from shredder openings. If object enters top opening, press and
hold Reverse (R) to back out object.
• Avoid touching exposed blades under Confetti-Cut shredder head.
2
E E N EN EN ENG ENGLISH ENGL ENGL ENGLIS ENGLIS ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH ENGLIS ENGLISH ENGLI ENGLISH ENGL ENGLISH ENG ENG GLISH
Model HD-10Cs Model HD-10C
See safety instructions below
Overheated (red)
Standby (green)
Safe Sense™ override switch
Control switch
Auto-On ( )
Off
Reverse (R)
Technology
™
Touch test area Sensor lights up
10
Maximum:
Sheets per pass (Confetti-Cut) .............................................................................10*
Cards per pass ....................................................................................................... 1
Passes per day ............................................................................................... 10-20
Paper width ............................................................................................9"/229mm
Continuous operation ............................................................................. 4-5 minutes
*20 lb., 8.5"x11" paper at 120v, 60 Hz, 3.8Amps; heavier paper, humidity or other
than rated voltage may reduce capacity.
• Never use aerosol, petroleum-based or other flammable products on or
near shredder. Do not use canned air on shredder.
• Do not use if damaged or defective. Do not open shredder head.
Do not place near or over heat or water source.
• 10 sheets per pass to avoid jams.
• The socket-outlet shall be installed near the equipment and shall be easily
accessible.

OPERATION

Continuous operation:
4-5-minute maximum
Handle
NOTE: Shredder runs briefly
Set to Off
after each pass to clear entry.
Continuous operation beyond
Grips
4-5-minutes will trigger
20-minute cool down period.
TROUBLESHOOTING
Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or all of the
below procedures.
Press and hold Alternate slowly back and forth
Reverse (R)
2-3 seconds
ATTENTION: If the SafeSense™ light remains on, you must engage the
SafeSense™ feature. (See SafeSense™ instructions below.)
SafeSense™ paper jam: If the SafeSense™ feature activates (SafeSense™ light remains on) to cause the user
to think the shredder has jammed when it has not, use the
feature and clear the paper. Warning – when switch is in override position, the SafeSense™ light will flash and
the SafeSense™ feature will NOT function. Once the paper is cleared, reset the SafeSense™ feature.
MAINTENANCE
Run regularly in reverse for Follow oiling procedure below and repeat twice.
one minute
Oil when bin is full, or
immediately, if:
• Capacity decreases
• Motor sounds different, or
Set to Off
Shredder stops running
WARRANTY
LIMITED WARRANTY Fellowes, Inc. ("Fellowes") warrants the cutting blades of the machine to be free from
defects in material and workmanship for 3 years from the date of purchase by the original consumer.
Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1
year from the date of purchase by the original consumer. If any part is found to be defective during the
warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes' option and
expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED
PAPER
Press Auto-On ( )
Feed into paper entry
and release
CARD
Press Auto-On ( )
Feed into paper entry
and release
Gently pull uncut paper
Set to Off (O) Press and hold
and unplug from paper entry. Plug in.
Reverse (R)
Override Switch in order to perform steps above. Once the jam is cleared, reset the
Override Switch to deactivate the SafeSense™
*Apply oil Press Auto-On ( )
Shred one sheet
across entry
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY
LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall
Fellowes be liable for any consequential or incidental damages attributable to this product.
This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid
worldwide, except where different limitations, restrictions, or conditions may be required by local law.
For more details or to obtain service under this warranty, please contact us or your dealer.
Set to Off
Shredder doesn't start:
Yellow - SafeSense™ active
Yellow flashing - SafeSense™ not active
Make sure head is on basket correctly
Wait 20 minutes for motor to cool down
Remove and empty basket
Sensor light illuminated–paper jammed
SafeSense™ override switch
Active Not active
Press and hold
Reverse (R)
2-3 seconds
0
/3505006
3