Power Mate Care - Kenmore Power-Mate KC50XBZRZU01 Owner's Manual

Always foltow a llsafety precautions when
cleaning and servicing the Power-Mate ®.
WARNING
Electrical Shock Or Personal
Injury Hazard
Disconnect electrical supply
before servicing or cleaning the
unit. Failure to do so could result
in electrical shock or personal
injury from cleaner suddenly
starting.
Although the dirt sensor feature in your
Kenmore Power-Mate ®isdesigned for years
of trouble free use, the passageof dirt
through the air passage system can coatthe
lens causing the green light to come on and
stay on - never switching to red.When this
happens the lens must be cleaned.
CAUTION
Never use water or any cleaning
solution when cleaning the lenses.
The residue of the water or cleaners
will accelerate the recoating of the
lenses and make cleaning necessary
sooner.
TO CLEANTHE LENSES
1. Removethe ._-
wandsby press-
ing the quick .=J
release pedal and
lifting up on the
wands.
2. As indicated by the illustration,the two dirt
sensor elementsare located on the inside of
the swivel, approximately3Y2inches/90 mm
down,(notethe arrows). Each element
shouldbe cleaned periodically.To reach the
sensor elements, use a small brush such as
a bottle brush.Brush each sensor element
severaltimes to removedust and dirt.
Cross Section View
Ap_prox.
3 P_, i nches
or 90 mm
•
i
NOTE: Looking downinside the swivel you
willsee a ring.The sensor elements are
locatedjust slightly below this ring.
3. Reinstallthe wandsaftercleaning the sen-
sors.