Advertisement
Available languages
Available languages
C _i:_ iii _ _ ,,_i!_
_,_iii_iii_
i: ii_ !!!_ii_ i__ _ _i_iii
ii_!!!ii_
_'_ '_;,_i _,_
_i_i_ii!iit_
:_i!!!ii_
iii_ ,_ii_ii_,
_ _ ....
1. Run water at faucet until it is hot. Turn
water off.
-,
2. Pull hoses out of their storage compart-
ment on the back of the dishwasher.
NOTE: Make sure the hoses are not
kinked or twisted. Kinked hoses reduce
washing performance.
3. Pull down on the locking collar while
lifting the hose connector onto the faucet
Locking collar
adapter.
4. When the connector snaps into place,
release the locking collar.
5. Turn the hot water on slowly until it is
all the way on.
6. Plug in power supply cord.
7. See the "Starting Your Dishwasher" sec-
tion for instructions on how to start
the dishwasher.
Hose
connector
You can draw water from the faucet while
the dishwasher is connected. Do not draw
water while the dishwasher is filling or while
water is being pumped out. (This helps pre-
vent a low fill when dishwasher is filling
or mixing drain water with fresh water.)
,, Press the red button on the hose connec-
tor to draw water from faucet. (The faucet
is set on hot. Adjust faucet for the water
temperature you want.)
NOTE: Turn hot water back on after you
draw water from faucet. Turn off cold water.
23
Advertisement
