Assembly - Weider PRO 800 User Manual

Before beginning assembly, carefully read the
following information and Instructions:
• Place all parts of the weight bench in a cleared
area and remove the packing materials; do not
dispose of the packing materials until assembly
is completed.
• Read each assembly step before you begin.
• For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART on the previous page. Note: Some
small parts may have been pre-attached for ship-
ping purposes. If a part is not in the parts bag,
check to see if it has been pre-attached.
• "13ghten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight bench, make sure
that all parts are oriented as shown in the draw-
ings.
THE FOLLOWING TOOLS (NOT INCLUDED)
ARE REQUIRED FOR ASSEMBLY:
• Two (2) adjustable wrenches
• One (1) phillips screwdriver .,_
• One (1) rubber mallet
• Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
.
.
Before assembling this weight bench, make
sure that you have read and understand the
information in the box above.
The weight bench is designed to be used with
a mid-width weight set (not Included). To use
an Olympic weight set, an optional Olympic
expansion kit (model no. 831.150780) is avail-
able for purchase. If you have purchased the
Olympic expansion kit, use the Olympic Crossbar
in place of the standard Crossbar [3] in this step.
Attach the Crossbar (3) to each Upright Base (7)
with four M10 x 81 mm Bolts (35), two Support
Plates (20), and four M10 Nylon Locknuts (19).
Note the position of the waming decal and
make sure that the Upright Bases are oriented
exactly as shown.
Slide the Uprights (1) into the Upright Bases (7)
and secure them at the desired height with the
M10 x 67mm Adjustment Knobs (30).
Attach the Frame (2) to the Crossbar (3) with two
M10 x 81ram Bolts (35) and two M10 Nylon
Locknuts (19).
1
3O
Waming
1
7
Decal
%
20 19
2
3
35
>
6