Weed Eater VS2000BV Instruction Manual page 10

Cleaning the air filter:
1. Clean the cover and the area around it to
keep debds from fal+ing into the carburetor
chamber when the cover is removed
NOTE: Move choke lever to RUN position
before opening air fi_ter cover.
2. Open air filter cover by pushing button
(see illustration) Remove air filter.
NOTE: Do not clean filter in gasoline or other
flammable solvent. Doing so can create a fire
hazard or produce harrc_JI evaporative emis-
sions.
3. Wash the filter in soap and water.
4. Allow filter to dry.
5. Apply a few drops of oil to the filter;
squeeze filter to distribute oil.
6. Replace parts.
REPLACE SPARK PLUG
Replace spark p_ug each year to ensure the
engine starts easier and runs better. Set
spark plug gap at 0.025 inch (0.6 mm) Igni-
tion timing is fixed, nonadjustable.
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder and dis-
card.
3. Replace with Champion RCJ-6Y spark
plug and tighten secure{y with a 3/4 inch
(19 mm) socket wrench.
4. Reinstall the spark plug boot.
REPLACE FUEL FILTER
To replace fuel filter, drain unit by run ning itdry
of fuel, then remove fuel cap/retainer assem-
bly from tank Purl fitter from tank and remove
it from the fuel line. Install new fuel filter on fuel
line; reinstal+ parts
Fuel Filter
CHECK MUFFLER MOUNTING
SCREWS
Once each year, ensure muffler mounting
screws are tightened securely to prevent
damage.
j-
Muffler
' Mounting
Screw
INSPECT MUFFLER AND SPARK
ARRESTING SCREEN
WARNING:
The muffler on this prod-
uct contains chemicals known to the State of
Catifomia to cause cancer.
As the unit is used, carbon deposits build up
on the muffler and spark arresting screen,
and must be removed to avoid creating a fire
hazard or affecting engine performance
Muffler Cover
Spark
'_ Arresting
/
/ Hood
/
Screws
Replace the spark arresting screen every 50
hours of operation or if any damage or breaks
in the screen are noted
NOTE: Do not attempt to c_ean the spark ar-
resting screen.
1. Remove 3 screws from muffler cover.
Remove muffler cover
2. Loosen and remove 4 screws from the
muffler hood.
3. Remove the muffler hood and spark arrest-
ing screen.
4. Install new spark arresting screen.
5. Reinstalt muffler hood and 4 screws. Tight-
en screws securely.
6. Reinstalt muffler cover and 3 screws.
Tighten securely.
NOTE: if any part of the muffler is cracked,
broken or damaged, we recommend that the
muffler be replaced.
-10-