Weed eater gas blower instruction manual (11 pages)
Summary of Contents for Weed Eater EBV 215
Page 1
Tout défaut de le faire pourrait entraîner des blessures graves. WEED EATER 1030 Stevens Creek Road Augusta, GA 30907 Trademark EBV 215 WEED EATER 5855 Terry Fox Way Mississauga, Ontario L5V 3E4 545117525 8/8/06...
SAFETY RULES IMPORTANT WARNINGS AND SAFETY INSTRUCTIONS WARNING: When using electric gardening appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and serious injury. The warnings and safety instructions in this manual must be followed to reduce the risk of fire, electric shock, or injury, and to provide reasonable safety and efficiency in using this unit.
Page 3
cian to install the proper wall outlet. Do not change the equipment plug, extension cord receptacle, or extension cord plug in any way. S To reduce the risk of electrical shock, use extension cords specifically marked as suitable for outdoor appliances. The elec- trical rating of the cord must not be less than the rating of the unit.
Page 4
When used as a blower, always install a blower tube. Use only recommended attachments. S To avoid spreading fire, do not use blower near leaf or brush fires, fireplaces, barbe- cue pits, ashtrays, etc. S Never place objects inside the blower tubes;...
Tube Release Button Blower Tube Blower outlet VACUUM ASSEMBLY NOTE: Assembly instructions for using your unit as a blower are explained in the previous section. If you have already assembled your unit for use as a blower, remove the blower tube.
Page 6
4. Align the grooves on the elbow tube with the grooves on the blower outlet. 5. Push the elbow tube onto the blower outlet until it snaps into place (elbow tube is secured by red tube release button).
Retainer Collection Bag Elbow Tube Vacuum Assist Handle Upper Vacuum Tube Lower Vacuum Tube INLET COVER LATCH is used to open INLET COVER LATCH and close the inlet cover and to secure the upper vacuum tube to the blower unit.
TUBE RELEASE BUTTON blower tube or elbow tube to the blower unit during operation. Also, pressing the tube release button allows removal of the blower tube or elbow tube.
Prepare unit for storage at the end of the season or if it will not be used for 30 days or more. If your blower is to be stored for a period of time: S Stop unit and disconnect from the power source.
Page 10
S Store your unit and extension cord in a well ventilated area and covered, if pos- sible, to prevent dust and dirt accumula- tion. Do not cover with plastic. Plastic can- not breathe and may cause condensation and eventual rust or corrosion. TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect from the power source before...