Installing A New Bag; Removing A Filled Bag - Frigidaire MTC500RBM3 Owner's Manual

Installing a New Bag
Before installing a new bag, be sure:
1. The drawer side is securely locked.
2. The container is clean and free of sharp debris that
may have punctured the bag.
Do not use any kinds of bags other than those designed
especially for use in your compactor. For the location of
your nearest genuine parts source, refer to the
"Requesting Assistance and Service" section.
1. Place folded bag into the drawer. Open bag and pull top
edges over the drawer top.
2. Lock bag in place by pulling the four prepunched holes
over the bag retainer buttons. Holes will expand over
the buttons without damaging the bag.
3. Press inside of bag against the drawer bottom, sides
and corners for a smooth fit.
Removing a Filled Bag
When the trash is compacted to the top of the drawer,
remove the bag. If the bag is too heavy, compact less
trash before emptying in the future.
Cut Hazard
Do not touch sharp objects that have cut through
the bag.
Doing so can result in cuts.
1. Pull the drawer completely open.
2. Remove top of bag from retainer buttons. Pull up all
four bag cuffs.
3. Close bag with twist tie provided.
o o
4. Push Side-Lock latch down and tilt drawer side open.
5. Lift out bag.
11