Table of Contents
Advertisement
Cutout dimensions
24" min.
Grounded elec-
trical outlet
must be
3" (7.6 cm) min.
from either side
well.,
18" rain.
(45.7 cm)
15¼" min.
(38.7 cm)
34¼"min.
(87 cm)
Clearance
dimensions
6" (15.2 cm)
clearance to the
nearest vertical
wall on the right
side of compactor
is needed to
remove bag.
\
_23"
(58.4 cm) clearance
in
front of the compactor
is
needed to fully open or
remove compactor drawer.
Freestanding
and
Undercounter
Installation
NOTE: Proper installation is your responsibility. Make
sure you have everything necessary for correct installa-
tion. It is the personal responsibility and obligation of the
customer to contact a qualified installer to assure that
electrical installation meets national and all local codes
and ordinances.
Tools and materials
needed for installation:
Level
Pliers
Scissors
Phillips Screwdriver
Flat-Blade Screwdriver
Utility Knife
Measuring Tape
_6" Box-End Wrench
Gloves
IMPORTANT:
• Slide compactor onto cardboard or hardboard
before moving compactor across floor to prevent
damaging floor covering.
• Do not allow the rear frame of the compactor to
touch the floor covering when lifting or moving
compactor.
Freestanding
installation
1. Use pliers to lower leveling legs away from cabinet.
Place level inside on the floor of the cabinet. Check
that the compactor is level from front to back and side
to side. Adjust the leveling legs until the compactor is
level.
2. Move the compactor close to its final position. Plug
the power supply cord into a 3 prong grounded outlet.
3. Carefully move compactor into its final position.
Check that compactor is still level. Repeat step 1
if necessary.
4. Grasp sides of compactor drawer and place bottom
of drawer into tracks. Lift at the handle so drawer will
go over drawer stops. Close drawer. Check if drawer
opens freely. If the toe plate rubs against floor, see the
"Adjusting the Toe Plate" section for further instructions.
Advertisement
Table of Contents
