Table of Contents
Advertisement
(SET
YOUR
TELEVIS
CHANNEL
1. Set your TV to channel 3 unless channel 3 is one of the TV stations in your area. If channel 3 is used in your
area, set your TV to channel 4 and slide the VCR/VHF OUTput Channel Selector toward channel 4. The
VCR/VHF OUTput Channel Selector is located on the rear panel at left side of the antenna connector. This is
the VCR channel on your television set. Your television receiver must be tuned to this channel any time a
video cassette is played ba(:k on the VCR.
VCR/VHF OUTput
Channel Selector
VCR
II
1111111111111111
rrll
1111111111111111
1111111111111111
D2J rrrrrrrr
t111111111111111
Ch 3 or Ch 4
2. Plug the VCR power cord into a 120V electrical outlet and press the "POWER" button. The "POWER" lamp
will light. The clock will flash repeatedly. This is not a malfunction (see page 7).
3. Press the "TV/VCR"
button. The VCR lamp will light. Select an active TV channel by pushing the VCR Chan-
nel Selector Buttons. The picture fromthat channel should now be displayed on your television.
I
Power ON
Ch 3 or Ch 4
TV/VCR Button
(NORMAL
TV VIEWING
)
1. Turn ON your TV receiver. There is no need to turn the POWER switch of VCR ON.
2. Tune your TV receiver to the channel you want to watch.
* The TV/VCR button should be set to TV position (The VCR Indicator lamp goes OFF.) if the POWER button is
turned ON.
4
Advertisement
Table of Contents
