Charging The Battery - Toro TimeCutter Z5000 Operator's Manual

2
6
G005071
Figure 31
1. Fuel line from tank 4. Fuel line to engine
2. Hose clamp 5. Flow direction arrow
3. Filter 6. Fuel tank
Electrical System
Maintenance
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Charging the Battery
Removing the Battery
,
6.
Squeeze the ends of the hose clamps together and
slide them away from the filter (Figure 31).
Remove the filter from the fuel lines.
Install a new filter vdth the flow direction arrow
coming from the fuel tank and pointing to the
engine. Move the hose clamps close to the filter
(Figure 31) to secure it in place•
Battery terminals or metal tools could short
against metal machine components causing
sparks. Sparks can cause the battery gasses to
explode, resulting in personal injury.
• When removing or installing the battery, do
not allow the battery terminals to touch any
metal parts of the machine.
• Do not allow metal tools to short between
the battery terminals and metal parts of the
machine.
,
,
,
,
Park the machine on a level surface and disengage
the blade control svdtch.
Move the motion control levers outward to the
park position, stop the engine, remove the key and
wait for aH moving parts to stop before leaving the
operating position.
Remove the left side console to access the
batter> Refer the Accessing the Battery procedure
in Premaintenance Procedures , page 23 for
instructions.
Disconnect the negative (black) ground cable from
the battery post (Figure 32)• Retain all fasteners.
29