Maintenance - Toro TimeCutter Z4200 Operator's Manual

Maintenance
Note: Determine the left and right sides of the m;_chine from the norm;_l operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Maintenance Procedure
Interval
Before each use or daily
• Check the safety interlock system.
• Check the air cleaner for dirty, loose or damaged parts.
• Check the engine oil level.
• Check air intake and cooling areas, clean as necessary.
• Check the cutting blades.
• Inspect the grass deflector for damage
• Clean the mower housing.
• Grease all lubrication points.
• Service the paper element. (more often under extremely dusty, dirty conditions)
Every 25 hours
• Check tire pressure.
• Check the belts for wear/cracks.
• Replace the paper element. (more often under extremely dusty, dirty conditions)
• Change the engine oil and filter.
Every 100 hours
• Clean the blower housing (more often under extremely dusty, dirty conditions).
• Replace the fuel filter.
Every 200 hours • Check spark plug condition and gap.
Every 500 hours • Replace the spark plug.
• Charge the battery and disconnect battery cables.
Before storage • Perform all maintenance procedures listed above before storage.
• Paint any chipped surfaces.
Important:
Refer to your engine operator's manual for additional maintenance procedures.
If you leave the key in the ignition switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug before you do any
maintenance. Set the wire aside so that it does not accidentally contact the spark plug.
22