Frigidaire TEF361ESC Use & Care Manual page 17

• Do not use abrasive cleaners and scouring pads, such as metal and some nylon
pads. They may scratch the cooktop, making it more difficult to clean.
• Do not use harsh cleaners, such as chlorine bleach, ammonia or oven cleaners,
as they may etch or discolor the cooktop.
Cleaning Recommendations for the Ceramic Glass Cooktop (cont'd)
Do not use the following on the ceramic glass cooktop: @@
• Do not use dirty sponges, cloths or paper towels, as they can leave soil or lint
on the cooktop which can burn and cause discoloration.
Door Hinge
locations
with oven door
fully open.
Fig. 2
Oven
Door,
Fig. 3
Fig. 4
Fig. 1
Special Caution for Aluminum Use on the Ceramic Cooktop:
• Aluminum Foil - Use of aluminum foil on a hot cooktop will damage the ceramic
cooktop. Do not use thin aluminum cooking utensils or allow aluminum foil to touch
the ceramic cooktop under ANY circumstances.
• Aluminum utensils-The melting point ofaluminum is much Iowerthan that ofother
metals. Care must be taken when aluminum pots or pans are used on the cooktop.
If allowed to boil dry, not onlywill the utensil be destroyed, but it may fuse to, break
or mark the ceramic glass surface, permanently damaging the cooktop surface.
Removing and Replacing the Lift-Off Oven Door
1_ The door is heavy. For safe, temporary storage, lay the door flat with the
inside of the door facing down.
To Remove Oven Door:
1. Open oven door completely (horizontal with floor- See Fig. 1 ).
2. Pullthedoorhingelocksonbothleftandrightdoorhingesdownfromtheovenframe
completely towards the oven door (See Fig. 2). A tool such as a small flat-blade
screwdriver may be required.
3. Firmlygrasp both sides ofoven dooralong the doorsides (Do not use the oven door
handle - See Fig. 3).
4. Close the doorto the broil stop position (the oven doorwill stop into this position
just before fully closing).
5. With the oven door in the broil stop position, lift the oven door hinge arms overthe
roller pins located on each side of the oven frame (See Fig. 4).
To Replace Oven Door:
1. Firmlygrasp both sides ofoven dooralong the doorsides (Do not use the oven door
handle - See Fig. 3).
2. Holding the oven door at the same angle as the removal position, seat the hook of
the hinge arm over the roller pins located on each side of the oven door frame (See
Fig. 4). The hook of the hinge arms must be fully seated onto the roller pins.
3. Fully open the oven door (horizontal with floor- See Fig. 1).
4. Push the door hinge locks up towards and into the oven frame on both left and right
oven door hinges (See Fig. 2) to the locked position.
5. Close the oven door.
Special Door Care Instructions - Most oven doors contain glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks are fully in place.
2. Do not hit the glass with pots, pans, or any other object.
3. Scratching, hitting, jarring orstressing the glass mayweaken its structure causing
an increased risk of breakage at a later time.
17