Table of Contents
Advertisement
Care
&Cleaning
Surface
Elements
and Drip Bowls-
Surface elements can be unplugged and removed to make cleaning the drip pans
easier. The surface elements clean themselves when they are turned on. Food spilled on a hot element will burn off. Food spilled
on a cool element may be cleaned with a damp cloth--any
remaining soil will burn offthe next time the element is used.
Hold
Down
(if el
Allow
Element
to rest
6r_ drip
pan
inside r=m.
Terminal
End
Terminal
Plug
Be sure the range is cool
before removing
elements
or drip bowls.
Be careful not to bend terminal ends when
replacing
elements
after cleaning.
Main top
Lift-up
Never immerse a surface element in water.
To Remove the Surface Elements
and Drip Bowls
1.
Lift the edge of the drip bowl across from the terminal end. Lift the surface
element and drip bowl together just enough to clear the cooktop.
2.
While holding the drip bowl and surface element, gently pull the terminal end
out from the terminal plug. If equipped, DO NOT remove the hold down clip from
the drip bowl.
To Clean Drip Bowls
Wash in hot, soapywater or in the dishwasher. Rinse and drywhile still warm. Hard
to remove, burned on soil can be removed by soaking the drip bowls for about 20
minutes in a lightly diluted liquid cleanser or a solution of ammonia and water (1/
2 cup ammonia to 1 gallon ofwater). A nylon scrubber may be used after soaking.
DO NOT use abrasive cleaners or steel wool, as they will scratch the surface.
Always rinse with clean water and polish dry with a soft cloth.
To Replace Drip Bowls and Surface Elements
1.
Slide the terminal end on the element through the opening in the drip bowl.
2.
Align the element support to rest on the rim inside the drip bowl. If your drip
bowl is equipped with a hold down clip, align the element support opposite the
terminal end with the slot in the hold down clip, and snap into place.
3.
After the element is positioned in the drip bowl, line up the terminal end with
the terminal plug as shown.
4.
Hold the surface element and drip bowl togetheras level as possible and firmly
push the terminal end into the terminal plug. Make sure element terminal is
seated properly into terminal plug. Make sure the surface element is level to
reduce the hazard of pans sliding off the element.
When lowering the lift-up
range top, grasp the sides with finger-tips
only. Be careful not to pinch fingers. DO
NOT drop or bend the range top when
raising or lowering. This could damage
the surface.
To Raise the Top for Cleaning
1.
Grasp the sides and lift from the front. Lift-up rods will support the top in a
raised position. Only lift the top far enough to allow the support rods to snap
into place.
2.
Clean underneath using a clean cloth and hot, soapy water.
3.
To lower the top, gently push back on each rod to release the notched support.
Hold the range top and slide the lift rods down into the range frame.
Cleaning
Oven Bottom
The bake element is designed to be gently tilted up using your hand from the front
of the bake element. This will allow easier access to the oven bottom for cleaning.
Be careful not to raise the element more than 4 or 5 inches from the resting position.
Baking
element
may be tilted about
4 or 5 inches
to clean oven bottom
Advertisement
Table of Contents
