Channel Selection; Sleeptimer - Sylvania LD320SSX Owner's Manual

[] Channel Selection
Select channels by using[CHA/V] or [the Numberbuttons].
• To select the memorized channels, use [CH •IV] or
[the Number buttons].
• To select the non-memorized channels, use
[the Number buttons].
To Use [the Number buttons]
- When selecting channel 11
When selecting digital channel 11-1
Be sure to press [-] before entering
the subchannel number.
• Press [CH RETURN] to return to the previously
channel.
About digital TV broadcasting:
With its high definition broadcast, digital broadcasting
far surpasses analog broadcasting in both its picture
and sound quality. Not all digital TV broadcasts are high
definition (HD). To confirm whether your watching TV
program is in HD, refer to the program guide, contact
your cable / satellite provider or local TV stations.
NTSC _ ATSC
(analog mode) (digital mode)
18:oo
........................ )_{:_
...................... 18:30
ii ii
]9:oo
ii!ii ........................
iiii_;;
_9:3o
20:00
can be changed by using [CH •/T].
What is the subchannel?
By using high compression technology, digital
broadcasting offers a service that enables multiple
signals to send simultaneously.
Therefore, you can select more than one program per
main channel since digital broadcasting technology
distinguishes between multiple channels broadcast by
a single network.
Note:
• "No Signal"willappearon the TVscreen after the
subchannel broadcast is over.
• "Audio onlyprogram" message will appear on the TV
screen, when you receiveonly sound signal
[] Volume Adjustment
Thissection describes h owto adjustthevolume. T hemutefunction, w hich
turnsthesoundoff andon, isalsodescribed.
Use [VOL._/_] to adjust the audio volume.
The volume bar will be displayed at the bottom of the
TV screen when adjusting the volume.
• The volume bar will automatically disappear in a few
seconds.
Press [MUTE D_] to turn offand on the sound.
MU_
"Mute" is displayed on the TV screen for a few seconds.
Press [MUTE D_ ] again or [VOL• _/_] to recover the
original volume.
[] Sleep Timer
Thesleeptimer canbeset toautomatically turnoff theunit after an
incremental p eriodoftime.
Press [SLEEP] to set the sleep timer.
Sleep timer display appears on the TV screen.
2 Press [SLEEP] repeatedly to change the amount of time
until shut off.
_#.!!/!( :>
You can set your unit to turn off after a set period of
time (from 30 to 120 minutes).
• Each press of [SLEEP] will increase the time by 30
minutes.
• After setup, the sleep timer display can be called up
for checking by pressing [SLEEP].
To cancel the sleep timer
Press [SLEEP] repeatedly until "Sleep Off" is displayed
on the TV screen.
Note:
• The sleep timer display will automatically disappear in a
few seconds.
• Whenyoudisconnecttheunitfrom theACoutletorwhen
a power failure occurs, the sleep timer setting will be
canceled.
EN