Checking And Changing The Program - Sony CDP-297 Operating Instructions Manual

CHECK
'1"1
---r--t _ t;::_
c) dl)
CLEAR
1o add a selection to the end ot the progranh lepuat the
programming procedure from the beginning (or simply press
the numeric button on the remote commander only for
CDP-397).
To delete a selection, press the CHECK button
repeatedly until the undesired selection is displayed.
vii
Then press the CLEAR button.
To change the order, press the • button in stop mode to
erase the program. Then repeat the programming procedure
from the beginning.
To check the remaining time
Press the TIME button once to see the remaining time of the
selection being played; twice to see the total remaining time;
once more to return to the initial display.
if you have inserted a pause, the display shows the
remaining time until the pause.
To check your program
Press the CHECK button. The first selection in the
VBI
program will be displayed.
Each time you press the CHECK button, the next selection in
the program will be displayed. After the last selection, "End"
will be indicated and the display will soon return to the initial
status.
While checking the program for side A, ,_"] appears and for
side B, _[-_-_B appears.
To change your program
You can make the following changes before starting play.
To erase the last selection, press the CLEAR button. Each
time you press the CLEAR button, the last selection in the
program will be erased.
To erase the entire program, press the • button once in
stop mode; twice during play.
The program is also erased when you turn off the unit or you
press the -_ OPEN/CLOSE button.
13